PowerSwitch Tail II Update 
Wednesday, January 13, 2016, 04:18 AM
Posted by Administrator
I have soldered a custom built breadboard to connect the Raspberry Pi to the PowerSwitch Tail II.

I am using the Wiring Pi pin #1 on this breadboard.

I have updated my web page at the bottom with details of the new breadboard.

See http://rocode.com/powerswitchtail/
view entry ( 1493 views )   |  permalink
PowerSwitch Tail II 
Sunday, December 27, 2015, 06:33 AM
Posted by Administrator
I got my soldering iron out again today and have assembled a PowerSwitch Tail II and connected it to a Raspberry Pi via the GPIO.

Using a Raspberry Pi I am able to programmatically turn a mains appliance on and off again.

Further details may be found at http://rocode.com/powerswitchtail/
view entry ( 1529 views )   |  permalink
PIR Soldered PCB 
Wednesday, December 9, 2015, 09:57 AM
Posted by Administrator
Today I got my soldering iron out after a very long time with it kept in my toolbox.

I replaced the solder less circuit I prototype last year (see http://rocode.com/sensors/#PIR) with the new soldered PCB shown below.

The green LED is lit when movement is detected by the PIR Module.

I purchased a spacing header strip from ebay and cut off a few for this PCB. However the pins are to short and the cables easily dislodge. I put sticky tape on them for now. I plan to buy another strip with longer pins and replace those used here.

I had lots of trouble working out what were the GPIO pin outs and the corresponding software pins in the WiringPi software (see http://wiringpi.com/). It appears that the pin numbers used in my download are somehow different to published current GPIO connector (see https://www.raspberrypi.org/documentation/usage/gpio/).

I am currently using a Raspberry Pi 2 Model B running with the Raspbian OS (see https://www.raspbian.org/). As the Raspberry Pi Zero was recently released I would like to try this with a USB Ethernet adapter as a cheaper replacement for the computer.
view entry ( 1669 views )   |  permalink
BFC3540 Modelling In Finance 
Friday, October 23, 2015, 01:57 AM
Posted by Administrator
I started teaching during 2015 in the subject BFC3540 Modelling In Finance at Monash University.

This is a 3rd year Subject within the Department of Banking and Finance on the Clayton campus.

There is now a page on Rocode for my Teaching Associate job.

view entry ( 1587 views )   |  permalink
From Morse To The Magnetron 
Friday, July 10, 2015, 09:15 AM
Posted by Administrator
The Geelong Amateur Radio Club hosted an event in July 2015 called "From Morse To The Magnetron".

The exhibition was a display of military communications equipment 1914 - 1960.

I have uploaded a number of photos to my ham radio website.


view entry ( 1761 views )   |  permalink

<<First <Back | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | Next> Last>>